MMP Citric Acid Cleaning Cartridge - Comfortable Coast

MMP Citric Acid Cleaning Cartridge: Your Ultimate Solution for Challenging Source Water!

Introducing the MMP Citric Acid Cleaning Cartridge, your essential defense against areas with extremely bad source water! This cartridge is a must-have, meticulously designed to combat hard water scale buildup by effectively descaling the plates within the water cell while proactively preventing future scaling. Crafted exclusively for use with the MMP Series water ionizer, it ensures top-tier performance, delivering pure, revitalizing water without compromise.

Embrace the power of the Citric Acid Ionizer Cleaning Cartridge and safeguard your investment for the long term. Prolong the lifespan and optimize the efficiency of your MMP water ionizer with ease. Experience uninterrupted access to exceptional water quality and indulge in the rejuvenating benefits of pristine hydration.

Elevate your water ionizer experience with the ultimate solution for challenging source water - the MMP Citric Acid Cleaning Cartridge. Protect and enhance your water ionizer for years to come. Get your MUST-HAVE cartridge now and revel in the refreshing taste of pure, revitalized water every day.

Directions For Using the MMP Citric Acid Cleaning Cartridge:

1. Turn off your ionizer and shut off the water supply going to the unit.
2. Locate the filter housing of your ionizer and remove the 2nd Filter. Have a towel handy to collect any residual water that comes out when you remove the filter.
3. Attach the Citric Acid Ionizer Cleaning Cartridge. Be careful not to over-tighten.
4. Turn on both the power to the ionizer and the water supply.
5. Run water through the ionizer using the H2O CLEAN mode for 30 seconds, then stop. Only use the H2O CLEAN mode during the cleaning process.
6. Allow the ionizer to sit unused for 3 hours.
7. For best results, repeat steps 5 & 6 for a total of up to 3 times.
8. When finished with the Citric Acid Ionizer Cleaning Cartridge, follow steps 1-4, replacing the cartridge with the original 2nd filter (or proceed with replacement filter instructions if changing both ionizer filters).
9. Run the unit on the H2O cycle for 3 minutes to wash the filter inside with clean water.
10. Lastly, feel free to check your pH levels of the machine and flow rate. The pH levels should return to normal.

Important Notes:

• Always use the H2O purified water level only when cleaning your Tyent machine to avoid damage.
• If your water ionizer is subject to hard water conditions, connect a Cell Safe Anti-Scale filter to prevent scale buildup on plates.

Features

• A MUST HAVE for areas with extremely bad source water.
• Designed to descale the plates located in the water cell and prevent future scaling.
• Specifically designed for use with the MMP Series water ionizer.